GB Intsruments Wire-Tracker GET-4110K Manual De Instrucciones página 4

To enhance the signal strength and
increase the operating range of the
receiver, the black alligator clip may
be connected to an external
equipment ground. This will greatly
increase the functional range of the
receiver.
Tracing Co-axial Wiring
To prevent interference, disconnect
the cable in the house from the cable
company wiring. This connection can
be found where the main cable enters
the house. Connect the co-axial plug
to any co-axial jack in the house.
Trace the wiring as described above.
Tracing Automobile Wiring
(GET-4110K Only)
! WARNING WARNING
• Do not use on any component of
the ignition system.
• Before using this device check
the vehicle's electrical wiring and
disconnect any component that is
5
sensitive to voltage and current
pulses such as air bags, electronic
control modules, etc.
• Do not connect the transmitter to
circuits for power-train, engine,
transmission, ABS brakes or any
other electronic control modules.
Locate the fuse box in the automobile.
Remove the appropriate fuse for the
wiring being traced. This will also
disconnect the power from the battery.
Insert the fuse plug into the non-
energized side of the fuse receptacle.
Trace the wiring as described above.
To boost the signal, the black alligator
clip may be connected to a suitable
ground, such as the car frame.
Tracing Data/LAN Wiring
(GET-4220K Only)
To prevent interference, remove all
connections from the data network to
any outside source. Use the RJ-45
(data) plug for insertion into a
standard data/LAN jack.
6