Using The Hair Clipper; System Set-Up; Connecting The Accessories; Connecting The Mains Power Cord / Charging The Battery - B.Braun Aesculap BASECut XT407 Instrucciones De Manejo

Aesculap Suhl GmbH
Hair clipper set XT407
3.

Using the hair clipper

3.1 System set-up

3.1.1 Connecting the accessories

Combinations of accessories that are not mentioned in
the present instructions for use may only be employed
if they are specifically intended for the respective
application, and if they do not compromise the perfor-
mance and safety characteristics of the products.
3.1.2 Connecting the mains power cord /
Charging the battery
Loss of capacity/performance due
to prolonged storage of hair clipper
with discharged batteries!
CAUTION Store hair clipper only in fully
charged condition.
Charge the hair clipper twice
every 2 months.
Note
The hair clipper heats up slightly during charging.
Note
Before first time use, the hair clipper should be charged
for at least 5 hours.
Note
The battery reaches its best capacity after 3 to 5 charg-
ing cycles.
Plug mains power cord 11 into mains socket.
Plug mains power cord 11 into DC socket 4 of hair
clipper.
The power indicator flashes while charging.
4

3.2 After using the hair clipper

Note
The blade set has the best cutting performance when it
is cleaned and lubricated after usage.
Unplug the mains power cord from the mains
socket and the DC socket 4 when not charging or
using the hair clipper.
Allow the product to cool down to room tempera-
ture.
Use the cleaning brush to remove any hair left on
the blade.
Lubricate blade ever so often, see Chapter 3.2.1.
Check the product for any damage, abnormal run-
ning noise, overheating or excessive vibration.
Inspect the blade for broken, damaged or blunt
cutting edges.
Set aside the product if it is damaged.

3.2.1 Lubricating the blade set

Push hinge to release blade set.
Gently pull blade set forward and slide it off he
blade hinge. Make sure that the blade doesn't fall
on the floor.
Wipe the surface between the blades with a dry,
lint-free cloth.
Place 2 to 3 drops of lubricant between upper and
lower blade and in the guide of the tension spring.
Slide the blade set onto the blade hinge.
With the clipper turned on, push the blade set
towards the hair clipper to lock the blade set into
position.