Mounting Guidelines - dirna Bergstrom COMPACTO T5 Instrucciones De Montaje

COMPACTO T5
EN
MOUNTING
GUIDELINES
• Prior to assembly, read the instructions and follow these
throughout the mounting operations.
• Use the appropiate tools for each operation.
• Make sure that the hoses of the cooling circuit are properly
attached and that they cannot come in contact with sharp or
hot points.
• When drilling or cutting, be very careful not to damage electric
wires or fuel pipes.
• All connections must be clean and some of the lubricating oil
used in the compressor should be applied before tightening
them.
• To avoid breaking or rupturing, the hose fittings must always
be tightened with two wrenches.
COMPRESSOR
• Check the alignment and tension of the belt.
• All elements must be kept closed in order to keep out
dampness and dust, which could cause possible problems
within the circuit.
• Special care should be taken not to damage the fins of the
condenser and the evaporator as this could affect the normal
performance.
ELECTRICITY
• Switch the connector off.
• Disconnect the battery before starting mounting operations.
• Verify that the electrical components have been connected
correctly.
• Verify that electric fans and turbines turn in the right direction.
References to position:
RIGHT: Driver´s right hand
LEFT: Driver´s left hand
!
If it is necessary to carry out cuts in cabin roof to
install equipment, the assembler will decide, under his
responsibility, whether the roof must be reinforced to avoid
possible deformations, breakages, water leaks, etc, using
the required means so that it does not happen.
HOSES
COILS
Driving torques (N.m.)
Fillet
M4/70
M5/80
M6/100
M8/125
M8/100
M10/150
M10/125
M12/175
M12/150
M12/125
M14/150
M16/150
Driving torques (N.m.)
Connection
3/8
1/2
5/8
Section
A
PV4
PV6
PV7
10
Steel Quality
Couple
8.8 10.9
2.9 4.2
5.5 7.5
10 13
22 30
23 32
45 61
50 67
78 105
94 125
119 143
120 165
185 255
Nut Couple
5/8 15-17
3/4 15-17
7/8 24/27
Belt tension
Kg
55
60
90
105
®
7
8
10
13
13
17
17
19
19
19
22
24