Carromco EVOLUTION-XT Instrucciones De Montaje página 12

05803, 05804
A detailed description of the various Game Modes and Options you can find inside the APP
under the section INSTRUCTIONS / GAME SETUP.
TROUBLE SHOOTING
1. NO CONNECTION
If the Connection status does not change from "...pairing" to "Connected" after more than
20 seconds from starting the App, go through each of the below points step by step:
-
Refer again to PREPARATIONS and make sure you have followed all steps from 1-6.
-
Check if the batteries are installed properly and if they still have power
-
Switch the BT Module Off and On again
-
Switch OFF and back ON the Bluetooth function of your device
-
Switch OFF and back ON the Location Service of your device
-
Exit and shut down the App completely and start the App new
-
Check if there is an update of the App available on Google Play or Apple App store. If
yes, download the update and restart the App
-
Are all other Bluetooth-enabled devices in the vicinity e.g. Bluetooth-Speaker switched
off?
-
Is the distance between Table and your device below 6 meters and physically
unobstructed?
-
Is the area free from potential sources of disruption, e.g. radio frequency emitting
devices such as microwaves, etc.?
2. GOALS NOT REGISTERED
If the App shows the status CONNECTED but scored goals on one or both sides are not
registered, check the following:
-
Check if the cables underneath the table are connected properly. Slightly push in on all
connectors to ensure proper connections.
-
The goal sensors are very sensitive. Make sure there is no dirt or foreign particles on
the sensor that could obstruct the signal.
-
Make sure that both sensors are exactly parallel to the goal line and facing each other. If
a sensor has become dislocated, gently move the sensor back into the correct position.
If none of the above measures can put the sensors back into operation, please contact the
Carromco Customer Service (see below) for further help.
3. POWER OR ELECTROMAGNETIC INTERFERENCE
Should there be an electromagnetic interference, the electronics of the table may possibly
show erratic behavior or fail to continue working. (For example: a heavy thunderstorm, a
power line surge, a rolling brown out, or too close proximity to an electrical motor or
microwave.) To restore the game to normal operation, take out the power adaptor from the
electrical outlet and the table for 2 seconds.
TABLE MAINTENANCE:

TABLE: Keep your table covered. If there is dust on the playfield or the aprons, use a
vacuum or wipe with a clean, soft cloth to remove. Do not sit on the table and do not use
the table outside.

RODS: Make sure that the bolts and screws on the players are tight. Occasionally wipe the
ENGLISH