Height Adjustment - Joyello JL-1047 Manual De Instrucciones

GB
3) Lift up the side of crib (fig 6) and attach the tubing to the tubing of the crib main body as illustrated.
Attach the studs on the tubing to secure (fig 7).
4) Fasten the side of the crib with the mesh window using the side zips and close them completely (fig 8).
At this point the product is ready to be used in "crib mode".
WARNING: always make sure that the side rail is raised , correctly attached and the zippers are completely
closed.
WHEELS
There are wheels located on the front of the frame legs for easy manoeuvring. To access wheels, hold
the crib rear long handrail and lift up. Simultaneously push the crib forward or backwards (fig 9). There
is anti-slipper at the bottom of leg to stop the crib moving.
LEG ADJUSTMENT
The leg at the base of the crib can be adjusted. Press button down as illustrated and pull leg out to adjust
the length (fig 10).

HEIGHT ADJUSTMENT

The crib can be adjusted to 6 different height positions. In order to adjust the height, press the adjustment
lever down and adjust the crib to the desired position (fig 11). Repeat this operation on the opposite
side. The base of the crib can be inclined slightly by adjusting the two legs to different heights (fig 12).
WARNING! The crib can be inclined with a maximum variance of 2 positions between one leg and the
other (for example: the right leg in position 3 and the left leg in position 1).
WARNING! The head of the child should always be positioned on the highest side.
CO-SLEEPING MODE (FIXING TO BED)
1) Open the side of the crib with the mesh window using the side zips and open them completely
(fig 13).
2) Press the removable tubular structure release button and remove partially on one side and then on
the other (fig 14). Once this operation has been performed on both sides, remove the tube (fig 14) and
fit it to the base of the crib using press studs (fig 15).
WARNING! Use the crib with the tube lowered in co-sleeping mode only.
3) Move the crib close to the parents bed and check the height of the crib compared with the mattress
of the bed (fig 16).
WARNING! The height of the parent's mattress should always be more than that of the side support for
containment of the crib.
WARNING! In co-sleeping mode the 2 legs of the crib should always be adjusted to the same height.
4) In order to fix the crib to the parents bed use the pair of straps provided (C). Fix the buckles underneath
the crib on both sides (fig 17). Ensure the second buckles are positioned above the strap belt. Next, fix
the straps around the structure/ slats of the parent's bed, from the bottom towards the top and fasten
the buckles below the crib to finish (fig 18).
5) To secure the crib to the parents' bed, pull the straps once again to make sure the crib is properly and
firmly secured to the parents' bed (fig 19).
WARNING! The distance between the crib and the parent's bed should be no less than 2mm (fig. 20).
15