Switch; Extension Cord Retainer; Preparing For Operation - Toro 51803 Manual Del Usuario

Switch

To turn your hedge trimmer "ON", depress and hold
the "lock-off" button, pull the switch trigger, then
release the "lock-off" button. Release switch trigger
to turn your hedge trimmer "OFF" (Fig. 4).
POTENTIAL HAZARD
If switch trigger is depressed in the "ON"
position and the trimmer is plugged into a
power supply source, trimmer will be
running.
WHAT CAN HAPPEN
Accidental starting of your trimmer could
result in serious personal injury.
HOW TO AVOID THE HAZARD
Before connecting your hedge trimmer to
power supply source, always make sure you
do not have the switch trigger depressed in
the "ON" position.

Extension Cord Retainer

An extension cord retainer has been provided to
prevent extension cord from becoming disconnected
from your trimmer during use. It is molded into the
switch handle of your hedge trimmer. Plug extension
cord into switch handle, then snugly fit cord into
retainer as shown in Figure 5.
Extension cord retainer works best with 16 A.W.G.
extension cords. When using 14 A.W.G. extension
cords the cord will be tight in extension cord retainer.
We suggest an alternate method as shown in Figure 6
for securing 14 A.W.G. extension cords.
EN–7
POTENTIAL HAZARD
Trimmer could operate improperly if any
parts are missing, damaged or broken.
WHAT CAN HAPPEN
An improperly operating trimmer could
cause serious personal injury.
HOW TO AVOID THE HAZARD
If any parts are missing, damaged, or
broken, do not operate your trimmer until
they have been replaced.

Preparing For Operation

For ease of operation your hedge trimmer has both a
front handle and a rear handle (Fig. 7).
POTENTIAL HAZARD
If front handle is not installed, trimmer
could be operated with only one hand.
WHAT CAN HAPPEN
Operating trimmer with only one hand
could cause serious personal injury.
HOW TO AVOID THE HAZARD
Check the front handle before each use.
Make sure it is securely fastened to your
hedge trimmer before using.
For your protection there is a blade guard between the
front handle and the blade.