Pur Line CHE-390 Manual De Usuario página 12

OPERATION
CONTROL PANEL
5 6 2
4
1. Main Power Button: Supplies power to all fireplace functions. Must be on for the fireplace to work.
2. Heater button: Controls the turning on and off of the heater. When the temperature unit is set to 'F' or 'C' , the
temperature range is as follows:
"F" = Temperature in degrees Fahrenheit 82°F ~ 62°F, ON/OFF.
"C" = Celsius temperature 27°C~ 17°C, ON/OFF.
3. Flame Adjustment Button: This button controls the brightness of the flame effect with settings of High (L3),
Medium (L2) and Low (L1). When the flame effect is first lit, the flame will be at the highest level. In subsequent
use, the flame's brightness will begin at the last setting used, unless the power to the appliance has been
interrupted. Each time this button is pressed, the brightness of the flame decreases.
The only way to completely extinguish the effect of the flame is to turn off the main power button (1).
4. Timer Button: Controls the on/off and 24 hour time setting from 0.5H to 6H. When the timer is first lit, it will
light at the shortest time setting (0.5H). Each time the Timer button is pressed, the time increases by 1 hour,
up to the longest setting (24 hours). Once the set time is over, all fireplace functions will automatically turn off.
5. Fahrenheit/Celsius Display: When the fireplace is lit, press and hold the Power Button for 5 seconds. A beep
will sound and the display will change between Fahrenheit and Celsius. The appliance will start with the last
heating setting used, unless the power to the unit has been interrupted.
6. Temperature/Timer Display: Displays the set point of the temperature and timer functions.
When either of these functions is activated, the display reflects the set point for five seconds and then turns off.
Any change to the temperature or timer setting will reactivate the display, which will fade again after five
seconds.
NOTE: After the
the fan (not the heater) will continue to run for about 1 minute to cool the inside of the appliance. During this
time, you may feel cold air from the fan outlet. This is normal and does not require any action. The fan will stop
once the interior cools down.
CAUTION - WARNING: Turn off the power before unplugging.
1
2
chimney has been
EN
REMOTE CONTROL
1
2
4
running, when the
10
3
appliance is turned off