dirna Bergstrom bycool green line LITE DAF XF Instrucciones De Montaje página 14

LITE
EN
Assembly
Recommendations
• Before starting assembly, please read instructions and
follow them during installation process.
• Use the adequate tools for each operation.
Electricity
• Disconnect ignition key.
• Disconnect battery before starting assembly.
• Make sure electric components are securely connected,
checking their correct fitting.
!
Caution: The power cabling is not included in the
standard assembly kit. Check availability of cabling
as an accessory.
! Warning
If the unit slants during assembly, wait for at least
60 minutes with the unit in horizontal position before
starting it up.
! Warning
When installing air conditioning equipment on roof,
the upper cabin part must be protected with a cloth
or a protective blanket to avoid possible scratches.
When installing LITE on roof, take into account
that, normally, cabins equipped with a hatch have a
strong enough structure to hold equipment weight.
However, if it is not the case and it is necessary to
carry out a cut in the roof or, although it has a hatch,
the material is not resistant enough (if roof is made
of fibre, plastic, etc...), it is the installer who will have
to decide, under his responsibility, if it is necessary
to reinforce the roof to avoid possible deformations,
breaks, water entries, etc., habilitating the means
required to stop it from occurring.
With DAF XF 105 high, plastic roof cabins, take
special care and only rest on cabin nerves to avoid
fibre part from sinking.
Torx wrenches set
Allen wrenches set
Open-jawed spanner 10, 13, 14, 20
Scissors
Flexo-meter
Documentation included
Mounting instructions
User's guide
Troubleshooting
Parts list
Warranty
Fragile
Beware of cuts!
Electrical hazard
!
The installing personnel must have a sufficient
training in vehicles air conditioning.
!
Dirna Bergstrom shall not be responsible for
breakdowns or damages coming from an inadequate
handling or installation of the equipment or from
modifications and substitutions carried out without
our express and written authorisation.
!
Equipment pre-charged with refrigerating gas.
(Do not handle refrigerating gas circuit).
!
Please see product warranty procedure included
in Troubleshooting.
!
Please see equipment User's Guide for its correct
functioning of the remote control and control panel.
!
Once installation is finished, the following documents
must be handed over to the user: User's Guide,
Warranty and Troubleshooting.
14
Tools
1001343622
1001335089
1001335088
1001343624
220AA10017
Symbology
! Warnings
®