Milwaukee PJ 710 Instrucciones De Uso página 6

Joining of
workpieces
Cutting grooves
in thin boards
Sawdust ejector
Exchanging the
blades
ENGLISH
1.
Apply glue to the grooves.
2.
Insert a biscuit dowel.
3.
Put together the workpieces and fix them with clamps, tightening straps, or similar.
The biscuit dowels well up due to the wetness of the glue, and the joint is additionally
strengthened.
When cutting thin boards (thickness of
material less than 16 mm) a thin piece of
wood must be placed under the swivel
fence, otherwise the groove is cut too close
to the surface of the board.
The following devices can be connected to
the sawdust ejector:

suction hose
(via suction nozzle )
 Milwaukee CleanLine System
(via suction nozzle )
 suction nozzle
 by–pass nozzle
It is recommended to use the Milwaukee
suction systems RSE or AS 3 W. Those
vacuum cleaners allow connecting the tool
directly to the socket of the vacuum
cleaner. The vacuum cleaner starts
automatically when the machine is switched
on.
1.
Loosen the four screws and remove the
cover plate.
2.
Depress the spindle lock and remove the
flange with aid of a pin–type face spanner.
Remove the blade.
3.
To insert a blade proceed in reverse order.
When inserting the blade, take care that the
arrows on the blade and on the base plate
conform.
5
1 3
2 4
PJ 710