Publicidad
Idiomas disponibles
Idiomas disponibles
Figure 1
Retaining clip
in locked
position
Figure 2
19° (6x16)
Red dot
26° (6x12)
Black dot
36° (6x9)
No dot
50° (4.5x6)
Yellow dot
Figure 3
Screw
Safety screen
Lens
Nut
Lens support pad
CE Source Four
Colour frame retaining clip
The colour frame holder is equipped with a spring-loaded retaining clip that
prevents colour frames and accessories from falling out of the holder.
Important: Hang CE Source Four with the colour frame retaining clip in the
locked position before using the luminaire.
1.
Release the retaining clip by pushing it sideways. The retaining clip will
pop open.
2.
Insert the colour frame.
3.
Press the retaining clip down until it locks into position.
Important: Use only CE Source Four colour frame.
Lenses
Note: Lens positions are not interchangeable within tube. Coloured dot on
lens must face forward. See figure 2.
Cleaning 19°, 26°, 36°, and 50° glass lenses
Caution: Change lenses if they become visibly damaged to the extent that
their effectiveness is impaired, for example, by cracks or deep scratches.
1.
Disconnect the unit from power before cleaning lenses.
2.
Remove the beam focus knob at the bottom of the barrel. Use a
crosshead screwdriver to remove retainer bolt 1 and spacer from the top
of the barrel. Remove the lens tube from the barrel.
3.
Remove the four pairs of screws and nuts that hold the lens halves
together. Do not dislodge the two larger nuts resting in the wells of one
barrel half. See figure 3.
4.
Lift out safety screen to access lens.
5.
Dampen a clean, lint-free cloth with vinegar or household ammonia. You
may also use water, but it will leave spots that you may remove by
polishing the lens gently with a clean, dry cloth.
Warning: Never use glass and window cleaner or any abrasive material
to clean the lens. Glass and window cleaners will stain the lens surface.
Abrasive materials (such as steel wool) will damage the lens.
6.
Starting from the centre, gently wipe the lens. Do not dislodge the four
small rubber pads that mount lens in place.
7.
Verify that dot painted on lens faces forward. Replace safety screen.
8.
Put barrel back together, using retaining clip to guide and secure the
halves in place.
9.
Replace screws and nuts.
10. Slide the lens tube back into the barrel with the colour frame retaining
clip on top. Replace beam focus knob and tighten bolt and spacer.
11
Publicidad
