Cleaning, Maintenance, And Storage; Cleaning, Maintenance And Draining; Storage - Maruyama MS0735W Manual Del Usuario

Ocultar thumbs Ver también para MS0735W:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

4. Cleaning, maintenance, and storage

Cleaning, maintenance and draining

For cleaning, check and maintenance, always be
sure to stop machine.
Check and maintenance items
for each season
Cleaning of air cleaner
・When elements become dirty or clogged,
reduced performance or difficulty starting is
observed. Clean the elements regularly to
remove dirt and prevent clogging.
・When cleaning the element, wash it using gaso-
line, dip it in the blended fuel used and install it
after squeezing it hard to remove excess fuel.
1
Disassembly
2
Clean
Gasoline
Squeeze
3
hard
Squeeze
Cleaning ignition plug
・Remove
car-
0.6~0.7mm
bon, and adjust
the clearance
Remove
to 0.6-0.7mm.
carbon
English
Pump
Check for worn piston packing and seal packing,
and replace worn one with new one.
※ For disassembly and maintenance, consult with
the sales outlet where you purchased the prod-
uct or sales office.
Drain
CAUTION
Make sure to drain, otherwise the pump might be
damaged by freezing in winter.
①Remove drain cap of chemical tank and hose
connecting screw of pump to drain residual liquid.
②Put fresh water into the chemical tank, start
the engine, spray from the nozzle to clean the
pump and inside of the hose.
③Operate for 15-20 seconds to drain residual
liquid at the throttle lever position, which is a
little bit back from full open position.
④Set throttle lever at low speed, and stop the
engine with the stop button.
Dip in the
blended fuel
15
CAUTION
Don't leave chemicals in the chemical tank and
pump. This might cause the machine to break
down.

Storage

1
Remove fuel from fuel tank, and operate the
machine in idling state until it stops.
2
Set pressure control valve handle to
"STARTING".
Hose contacting screw
3
Move throttle lever to low-speed position.
Drain cap
Throttle lever
4
Maintenance of cylinder
①Remove plug.
5
After finishing the above, put the machine in
a box and store it at a place free from mois-
ture and which is well ventilated.
CAUTION
STARTING
・When damage is found, store it after making
repairs. In this case, use the genuine parts
specified by us for all parts and consumable
goods.
・Store at a place that is free from moisture,
dust, and contaminants.
H
L
16
②Few drops of oil.
③Pull two or
three times.
④Put in plug.
English

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ms0735wce

Tabla de contenido