Nikon StabilEyes 14x40 Manual De Instrucciones página 10

How to Use and Focus
1. If you wear glasses or sunglasses when
using binoculars, fold back the rubber eyecup
on each eyepiece (ocular lens) so you can view
complete images.
2. Next, grasp either eyepiece and rotate it
towards or away from the center of the
binocular (the other eyepiece will move equally
in the opposite direction.)
Adjust the interpupillary distance to match the
distance between your eyes until you see just
one perfectly round image.
3. There are two steps to focusing: Close your
right eye and use only your left eye as you
adjust the focus control knob (3). When the
image is sharp, close your left eye and open
your right eye. Twist the right eyepiece, to
focus for the right eye. Now open both eyes
and the binocular should be perfectly focused.
You can do this with the StabliEyes turned on
with stabilizing activated or with the power off
completely.
18
4. The StabilEyes power on/off sequence is
simple. Pressing the POWER ON button (1) the
first time activates an internal system check,
causing the LED I (located between the two
eyepieces) to glow orange. Pressing the
POWER ON button a second time activates
stabilization, and the LED I turns green.
The stabilization mode default is set for LAND
mode (LED II: green). Pressing the MODE
button changes it to ON BOARD mode (LED II:
orange). Pressing the MODE button causes
StabilEyes to switch modes, from ON BOARD
to LAND, or vice versa. Simply select the
stabilization mode that best suits your viewing
situation.
If you press the same button a third time, the
StabilEyes goes on standby (orange LED I
again). Press it again, stabilization is
reactivated. You may repeat this process as
often as you wish. Reverting to standby
conserves battery power. On the other hand, if
you leave the StabilEyes in either standby or
stabilization mode for about three minutes
without using it, it will shut itself off
automatically.
Operating System of StabilEyes
* Turning the power off automatically resets the vibration reduction mode to "Land" mode.
Press the
ON button
Power on
The system powers up
LED I
and performs a
orange
5-second system check
If StabilEyes is left in standby or stabilization mode for about three
minutes without using, it automatically shuts off.
Press the
ON button
LED I
Stabilization is
in standby orange
Pressing the ON button causes StabilEyes
to switch from Standby to Active, or vice versa.
Press the
MODE button
LED II
ON BOARD
mode orange
Pressing the MODE button causes StabilEyes
to switch modes, from ON BOARD to LAND, or vice versa.
Press the
OFF button
Power off
LED I•II
Stabilization is
turned off off
LED I
Stabilization
activated green
LED II
LAND mode
green
19