General Safety Guidelines - Master WiCloud Serie Manual De Usuario

GENERAL SAFETY GUIDELINES

CAUTION Before beginning to install this machine, carefully read and understand the
following safety guidelines.
The installation of the device and any repairs must be carried out by skilled and qualified
technical personnel.
Plastic bags, polystyrene, small metal parts such as nails, staples, etc. must not be left within
the reach of children as they represent potential hazards.
The device is not intended to be used by persons (including children) whose physical,
sensory or mental abilities are reduced or who lack the necessary experience or knowledge,
unless a person responsible for their safety provides supervision or instructions concerning
the use of the device.
Before connecting the device, check that the electric power supply used has the same
characteristics indicated on the technical data label, attached to the device.
This machine is intended only and exclusively for the use for which it was designed, and the
manufacturer cannot be held liable for damage due to improper use.
The actuator is designed for internal installation. For any special application, it is highly
recommended that you consult the manufacturer in advance.
Do not wash the device with solvents or water jets.
Do not submerge the device in water.
Always request the use of original spare parts only. Failure to observe this rule may
compromise safety and void the warranty applied to the device.
Hopper windows present the hazard of injuries caused by the accidental fall of the window.
Check that the selected stroke-end allows the window to open without encountering any
obstacles whatsoever.
The device must be installed following the manufacturer's instructions. Failure to observe
these recommendations may compromise safety. The electrical power supply system must
be designed and implemented in compliance with current standards.
Crushing or dragging hazard. During operation, when the actuator closes the window, it
exerts a force of 200N on the stops of the fixture; this pressure is enough to crush your
fingers in case of distraction.
Check that the selected stroke-end is at least one centimeter from mechanical stops, stroke
limiters or any physical obstacles to the opening of the sash.
In the event of a failure or malfunction, switch the device off using the power switch and call
a qualified technician.
Pagina 11