Rechner Sensors LevelMaster ET Instrucciones De Uso página 11

ET = Easy Teach Push Button
Test
The test function can be used to check the control system that is connected to the sensor.
• Press the EasyTeach button with the screwdriver
and hold it until the yellow-green LED is flashing
and the outputs switch pulsating at the same
time.
For leaving the test mode release the EasyTeach
button. The sensor returns to the previously ad-
justed state.
ETW = Easy Teach by wire
• Connect the grey teach wire (Pin 5) to the supply
voltage and hold it until the LED is flashing yel-
low-green and the outputs switch pulsating at the
same time.
Leave the test mode by disconnecting the grey
teach wire from the supply voltage. The sensor re-
turns to the previously adjusted state.
11