Nikon MONARCH 7 Manual De Instrucciones página 6

(2) Magnification
En
• The MONARCH 7 Riflescope has variable magnification. For details, see "2. Specifications".
To change powers, rotate the power selector ring until the desired magnification appears adjacent to the power index dot.
(3) Adjustment of the riflescope
Sighting through the riflescope, align the rifle with your aiming point on the target and shoot a trial round. If the bullet does not hit the aiming point, adjust the elevation and windage as follows:
• If the bullet hits under the aiming point, turn the elevation adjustment turret (counter-clockwise) in the direction of the arrow marked "U" for up. If the bullet hits high, turn the elevation adjustment turret (clock-
wise) in the direction of the arrow marked "D" for down.
• If the bullet hits to the right of the aiming point, turn the windage adjustment turret (clockwise) in the direction of the arrow marked "L" for left. If the bullet hits to the left of the aiming point, turn the windage
adjustment turret (counter-clockwise) in the direction of the arrow marked "R" for right.
• For the high profile turret, adjustment is made by turning the turret by hand. If the bullet hits under the aiming point, turn the turret in the direction of the arrow marked "U". If the bullet hits to the left of the aim-
ing point, turn the turret in the direction of the arrow marked "R".
• After the reticle has been adjusted to the point of impact, replace the turret cap for both the windage and elevation adjustment turrets.
10
MONARCH 7.indb 10-11 MONARCH 7.indb 10-11
(4) Zero setting of adjustment turrets
After the reticle has been adjusted to the point of impact, pull out the adjustment turrets. The adjustment turrets can now be turned freely. Align the zero
number to the index line, and then push the turrets back in, to set the current position to zero. Place the turret caps on the adjustment turrets.
(5) Changing the turret*
With the turret held with your fingers to avoid shifting of the aligned scale ring, turn the screw in the top of the turret counter-clockwise with a coin until the
screw comes out (Fig. 3-2). Remove the turret.
Insert the new turret into position and align the scale ring to 0.
Insert the screw. By securing the turret with your fingers to avoid shifting of the scale ring, turn the screw clockwise with the coin, until the turret is firmly
secured.
*Please refer to "Supplied Item(s)" to see if your riflescope is provided with high profile turrets.
En
Fig. 3-2
11
1/17/2013 10:22:19 AM 1/17/2013 10:22:19 AM