Installation; Location; Reversing The Door Swing - Continental RCC212NEWWY0 Manual De Usuario

Installation

Location

When selecting a position for your unit you
should make sure the floor is flat and firm,
and the room is well ventilated. Avoid lo-
cating your unit near a heat source, e.g.
cooker, boiler or radiator. Also avoid direct
sunlight as it may increase the electrical
consumption. Extreme cold ambient tem-
peratures may also cause the unit not to
perform properly.

Reversing the Door Swing

Tools Required:
• Phillips screwdriver
• Flat blade screwdriver
• Wrench
1. Remove the right top hinge cover.
2. Remove the screws holding the top hinge using a cross slot screwdriver.
20
This unit is not designed for use in a ga-
rage or outdoor installation.
Do not drape the unit with any covering.
When installing the unit, make sure that 10
cm of free space is left at both sides, 10 cm
to the back and 30 cm to the top of the
unit. This will allow fresh air to circulate
around the unit and improve the efficiency
of the cooling process.
Right top
hinge cover
Two screws