Delta BS150LS Manual De Instrucciones página 11

9. Loosen the screw (T) Fig. 16 and align pointer (S) with
"0" mark on the trunnion scale (M). Tighten securely.
NOTE: Make sure table is set at 90 degrees to the blade
or check the pointer alignment after adjusting the table
stops (see section"ADJUSTINg THE TABLE POSITIVE
STOPS").
10. Re-assemble the screw (W) Fig. 17 that was removed
in STEP 2, down through hole in table. Place the M6
flat washer (Z) on the M6 x 30mm screw, then thread
the M6 wing nut (X) on the screw (W) and tighten
securely.
ATTACHINg LAMP TO MACHINE
1. Fasten the lamp bracket (A) Fig. 18 to the top cover
of the machine, using two M6 x 0mm socket head
nylock screws (B) and M6 lockwashers. Tighten
securely using the 5mm hex wrench provided.
. Peel the backing from the cord clamps (C) Fig. 19,
and apply one clamp at each of the locations shown.
Make certain the lamp cord is routed out of the way
of the blade, then secure the cord (D) to the cord
clamps (C) Fig. 19.
3. The flexible lamp operates independently of the band
saw. To turn the lamp on and off, rotate the switch
(E) Fig. 19.
To reduce the risk of fire, use 40 watt (or
less), 120 volt, reflector track type light
bulb (not supplied). A standard household light bulb
should not be used. The reflector track type light bulb
should not extend below the lamp shade.
Z
A
B
E
11 11
11
Fig.16
W
X
Fig. 17
Fig. 18
D
C
C
Fig. 19
M
S
T