Publicidad
Idiomas disponibles
Idiomas disponibles
HOW TO CONNECT WITH STENTS PRODUCTS
Product feet frame diagram:
Put the product's fixed holder on heater with 5*12 screw.
Put the fixed axle into the hole of tube, and then put them in the fixed axle sleeve and fixed
spacer respectively.
Put the heater which is installed on fixed holder into fixed axle according to step 2, and both
sides lock with located knob.
The product is connected in stents
After adjust the symmetrical distance
of the side on the holder which of the
heater, locking the 5*12 screw on the
fixed holder
MAINTENANCE
It is necessary to wipe periodically the heater and the reflector, depending on the
Place and the circumstances of its use.
Cleaning or replace the reflector:
Publicidad
