Measurement Of Pulse Rate And Blood Pressure; Memory Function; Saving The Reading; Memory Recall - Terraillon PRESSIO A Instrucciones De Uso

54119 notice Pressio A v7 7/09/05

7 Measurement of pulse rate and blood pressure

• Press the "START/STOP" button.
• All display symbols appear for approx. 2 seconds.
This is the initial LCD test.
• When the monitor completes the necessary
preparations before measurement, the last reading
result will be shown on the display for 1 second.
• Then the monitor begins to measure
your blood pressure, and you will see
the inflation symbol on the display
when inflating. During the process of
deflation, the symbol of inflation will
turn off and the symbol of deflation
will turn on instead.
• After the measurement is completed, your blood
pressure and pulse will be displayed on the LCD
automatically.

8 Memory function

8.1 Saving the reading

• Your "Pressio A" can store data from up to 60 measurements.
• Once the 60 measurements are recorded, each subsequent reading
replaces the "oldest" in the memory.
26
14:11 Page 26

8.2 Memory recall

• To recall the memory, please press "MEM" button first. Then, the average
result of all stored measurements will be shown on the LCD first.
• After the average reading is shown on the display, you can press "MEM"
button to track historical records from no.1 to no.60.
Press "MEM"
• To come back to the first records, please press "SET" button.
This function is available only after readings have been saved to memory!
If no data has been stored, the display will go directly to the "setting date
and time" function.

8.3 Memory deletion

While in power off mode, press "MEM" button and hold it until the screen
shows "Clr" .

9 Care and maintenance

9.1 Care and maintenance
• If necessary, clean the device only with a slightly moistened cotton cloth
or mild detergent.
• Do not disassemble, repair or remodel the monitor.
• Do not expose the monitor to extreme temperature, very high humidity,
or direct sunlight.
• Avoid dropping and rough handling.
• Do not immerse the device in water. It may cause damage if water
enters.
• Do not use any gas, strong detergent, or solvents to clean the device,
including the arm cuff.
• Batteries should not be discarded with domestic waste!
Please dispose of batteries only in the disposal bins
provided in shops.
Press "MEM"
27