Descargar Imprimir esta página

Power Supply; Starting Up The Unit - Nedo X-Liner 360 2 green Manual De Instrucciones

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 37

5 Power Supply

When starting up the X-Liner 360 2 green for the first time, install the batteries (4) supplied, as
shown in the battery compartment.
Insert /replace batteries
Operation of the X-Liner 360 2 green requires
4 batteries 1.5 V (AA).
• Lever open the locking clip of the battery
compartment cover and fold it out.
• Insert/replace batteries as specified.
Ensure pole direction is correct!
• Re-close the battery compartment cover and
press on until the locking clip latches back into
position.
6 Operation

6.1 Starting up the unit

• Set up or fix the unit according to the intended use. Ensure the levelling
range of ±3° is not exceeded.
• If using the tripod, level the unit roughly using the adjustable unit feet
(3). The setting can be checked using the circular bubble (5). The
X-Liner 360 2 green is correctly levelled if the air bubble is located in
the middle of the circle.
• Lock the pendulum locking device for use without self-levelling. To do
this, push the unit switch into position 1
button to switch on the unit. The laser lines flash slowly (every 4
seconds).
• Release the pendulum locking device for use with self-levelling. To do
this, push the unit switch into position 2
button to switch on the unit. If the laser lines flash quickly the
X-Liner 360 2 green is outside the self-levelling range. The laser must
then be moved to within its levelling range.
• If you have finished working with the unit, lock the pendulum locking
device and use the ON/OFF button (press for 3 secs.) to switch off the
unit.
X-Liner 360 2 green
OPERATING INSTRUCTIONS
1
If the batteries' charge is weak, the laser
The laser switches off if the batteries
and use the ON/OFF
and use the ON/OFF
2
beams begin
to flash.
are too weak.
Alignment of the
circular bubble
Wrong
Correct
EN
13

Publicidad

loading