Typical Applications; Installation; Wiring Diagrams; Maintenance / Cleaning - Vortice CA MD RF Manual De Instrucciones

ENGLISH

Typical applications

See Figures 1-5;
The images shown refer to typical applications for this
product.
In particular, in Figure 1, it is possible to check the
correct orientation of the product from duct:
A = intake
B = delivery

Installation

See Figures 6-12.
The images shown are purely indicative.
purpose is to illustrate the main assembly steps for
the entire range.
IMPORTANT: See the "Wiring Diagrams" paragraph
to check the 3 ventilation speeds.
IMPORTANT
If the unit does not have piping connected to the
suction point (free suction) and it is installed at a
height lower than 2.3 m, assembly of the protection
grille - suction side (fig. 6-7) is required.

Wiring diagrams

See Figure 13A.
Connection with the optional device upon request is
foreseen to check ventilation speeds (device not
supplied in packaging):
- 13A) Vortice 3-speed selector Code 12.869.
IMPORTANT
Vortice guarantees correct product operation and
control only when paired with the Vortice 3-speed
selector (Code 12.869).
Other types of connection
Alternatively, other
available, associated to different control modes
(devices provided by the installer).
Connection alternative for new installation
- 13B) Pairing with 3-switch control;
- 13C) Pairing with Electronic dimmer.
Machine replacement on existing system
Connection without modifications to the electrical
system: the same switches as on the existing system
will be used. CAUTION: it will not be possible to
connect all 3 available speeds but only those for
which the electrical system is set up (to be chosen by
the installer):
- 13D) Speed connection: Minimum and Maximum;
- 13E) Speed connection: Medium and Maximum.
connection diagrams
CAUTION
Correct operation of ERP 2018 is only guaranteed
when set in compliance with the connection diagram
13A).

Maintenance / Cleaning

Fig 14-17.
Their
are
9