Erreka LEOBOX Manual Del Instalador página 14

UNPACKING AND FITTING
12
Installer's manual
4 Place the case in position for fitting and mark the
position of the screw holes (6), the hole for the
release cable and the hole for the electrical wires.
5 Drill the screw holes (6) using a
6 Drill the hole for the release cable and the hole for
the electrical cables
7 Insert the four wall plugs (7) and insert the release
cable (9) in the case, ensuring that the cable extends
beyond the sleeve by some 30mm.
8 Insert the electrical cables (5) through the bottom
hole on the back.
9 Secure the case with the four screws (8).
10 Remove the closing cover (10).
11 Insert the steel cable and secure it by fully tightening
the screw (12).

Use a 2mm Allen wrench.
12 Place the release handle (11) in the position shown
in the figure and adjust the tension of the cable,
taking into account that in this position the door
actuator will be locked.
13 Fit the cover (10).
14 Connect the contacts (NC, NA y COM) on the
microswitches to the electrical wires.
15 Fit the cover (4) with its screw (3).
ø
6mm bit.