Remote Controller - Fujitsu ABYG45LRTA Manual De Funcionamiento

Ocultar thumbs Ver también para ABYG45LRTA:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 53
NAME OF PARTS

Remote controller

Display panel
1 MODE button
2 10 °C HEAT button
3 SET TEMP. button (
4 ECONOMY button
5 SLEEP button
6 FAN button
7 START/STOP button
8 SET button (Vertical)
9 SET button (Horizontal)
0 SWING button
A TIMER MODE button
B TIMER SET (
C CLOCK ADJUST button
D RESET button
E TEST RUN button
This button is used when installing the
l
conditioner, and should not be used under
normal conditions, as it will cause the air
conditioner's thermostat function to operate
incorrectly.
If this button is pressed during normal
l
operation, the unit will switch to test run
mode, and the indoor unit's OPERATION
indicator lamp and TIMER indicator lamp
will begin to flash simultaneously.
To stop the test run, press the START/STOP
l
button to stop the air conditioner.
/
)
/
) button
Display panel
To facilitate explanation, the accompanying illustration has
been drawn to show all possible indicators; in actual oper-
ation, however, the display will only show those indicators
appropriate to the current operation.
F Signal transmitter
G Temperature SET indicator
H Operating mode indicator
I SLEEP indicator
J Transmit indicator
K Fan speed indicator
L SWING indicator
M T imer mode indicator
N Clock indicator
Some indoor units may not be equipped with the functions
corresponding to all of the buttons on this remote
controller. The indoor unit will beep and the OPERATION,
TIMER and ECONOMY lamp flash when a remote
controller button is pressed if the function is not available.
En-5

Publicidad

Tabla de contenido
loading

Tabla de contenido