Tabla de contenido
Publicidad
Before using the DMX512 controller, you should set the channel address.
can be set 001~511 address, every binary address switch has a digital no,
please refer to:
No.
Digital No.
1st
1
2nd
2
3rd
4
4th
8
5th
16
DMX Control Parameter Chart
Channel No
DMX512 fig.
0~69
70-139
Channel 1
Control mode
140~209
210~255
Channel
Pattern
0-33
2
Selection
34~255
Channel
Strobe
3
Channel
Spot and line
4
1~160
Horizontal
161~190
Channel
move
191-220
5
221-255
1~160
161~190
Channel
6
191~220
Vertical move
221~255
Channel
Zoom(+/-)
0-255
7
pattern size
Channel
0-255
8
Reset
©Copyright LOTRONIC 2012
No.
Digital No.
6th
32
7th
64
8th
128
9th
256
10th
Function switch
Content
Shut off
Sound control
Auto play
Manual
Static pattern
Dynamic Geometric pattern
8 grade speed 0-255)/30=0-8do
0-255
0-255
From line to spot effect
Manual
From left to right move
From right to left move
Right and left in-phase move
Manual
From down to up
From up to down
Up and down in-phase move
pattern size change
When the number exceeds 200, the
unit will reset
It
☆ Please clean the lens regularly. Do not do it using the wet cloth or other
chemical. the clean times is depend on the using frequency and
surrounding condition; it is recommended that should be cleaned every 20
days;
☆ Please clean the lighting surface and engine outlet regularly.
☆ Be sure that there is no flammable or explosive subject nearby. The least
distance is 0.5 meters. at the same time, keep more than 15cm between
the wall and laser lighting;
Power off before installation or maintenance;
The danger class of this laser lighting is CLASS 3 B. it's dangerous for
observing laser. The safe minimum distance is 13cm,the safe maximum
time is 10 seconds;
Keep at least 0.5 meters distance between the lighting and flammable
material;
1. Laser diode: DPSS green 532nm, red 650nm, blue 450nm
2. Power supply: AC200V—240V, 50/60Hz
3. Laser power: Red 100mW, 30mW green, 100mW blue, 130mW yellow,
200mW pink
4. Motor:
N1.8 high precision step motor
5. Control mode: sound control/auto/DMX
6. Dimensions: 650 x 220 x 163mm
7. Net weight: 5.8KG
8. Gross weight: 7KG
GB - This LASER effect is built for PROFESSIONAL use only. It must be used and controlled by a
professional in sufficiently large premises because of its high output power. Always set up and install all
laser effects so that all laser light is at least 3 meters (9.8 feet) above the floor. Never create a fixed point.
Maintenance
Warning
Technical parameters
Page 2
Publicidad
Tabla de contenido
