Safety Warnings - S&P ECOHAND N Manual De Instrucciones

ENGLISH
Before installing the appliance, carefully read these instructions and keep them safe for futu-
re reference. ECOHAND N hand dryer has been designed in compliance with safety standards
IEC 60335-1 and IEC 60335-2-23, and manufactured under strict production and quality control
standards. All components have been verified and all appliances have been thoroughly checked
afterassembly.
We recommend you check the correct condition and operation of the appliance as soon as you
unpack it. Items that are defective on arrival will be covered by the S&P guarantee.

SAFETY WARNINGS

• If the appliance is installed with a direct connection to the electri-
city network, the installation should be carried out by a qualified
installer, in line with the national electrical installation standards.
• If the appliance is installed with a direct connection to the electri-
city network, it must be connected via a differential switch (RCD)
with a rated residual operating current not exceeding 30 mA.
• If the appliance is installed with a direct connection to the electrici-
ty network, it must be equipped with a power disconnection switch
with a contact separation of at least 3mm on all poles.
• Check that the power supply voltage matches the voltage stated on
the rating plate.
• Any interventions or alterations that change the normal operating
characteristics of the appliance represent a potential source of
risk.
• This appliance is an electrical appliance for drying hands. It should
not be used for other purposes, such as drying clothes, etc.
• If the power supply cable is damaged, it should be replaced by
the S&P after-sales service or by qualified personnel to avoid
the risk of electrocution.
• This appliance should not be used in the immediate vicinity of bath-
tubs, showers, wash basins or any other vessels containing water.
8