Fermax LOFT DUOX Manual De Instalador página 25

L L L L L OFT DUO L L L L L OFT DUO OFT DUO OFT DUOX X X X X OFT DUO OFT DUO OFT DUO OFT DUO OFT DUOX X X X X
OFT DUO
The selected option is displayed with the white line under the icon. Press and a screen
appears confirming the selected option (image of a face) and a beep sounds on the monitor.
The monitor will automatically connect wit the street panel, activating the camera. Enter the
calling code for this monitor from the panel. Depending on the type of panel installed:
- pressing the corresponding button or
- by entering the code + bell.
Notes:
- The time between steps 4 and 5 must be less than 2 and half minutes.
- Programming is always done from the panel activated as the master panel.
2222
F1
MENU
A different call tone is produced, confirming the monitor's programming and the camera's image
is still viewed. After a few seconds the monitor returns to standby.
Option 2: From the Monitor: Monitors can be programmed on the screen menu.
Program the call number: Press on the previous screen and access the screen to program
the residence's number (numbers from right to left).
Each time the + is pressed the number increases (starting with 1) and the arrow is used for
moving the cursor. A white cursor indicates where the digit will be entered. Program the
corresponding number and accept with .
Page 9