Little Giant M13 Instrucciones De Funcionamiento página 18

B. RATCHET Leveler Lubrication Instructions
Note: If your ladder is equipped with RATCHET levelers, they should be lubricated at the
same interval and with the same dry lubricant as the hinge locks and outer ladder locks,
as mentioned above.
EN
1. D-ring release lubrication instructions
a) Start by removing the outer ladder assembly with the RATCHET Levelers from the
inner ladder assembly.
b) Generously apply the dry lubricant inside the tops of the leveler legs, coating the inside
of the faces with the holes for the locking pins (Fig. 64).
c) Extend the RATCHET levelers, and generously apply the dry lubricant to all external
surfaces of the leveler legs, making sure not to get any of the lubricant on the ladder
feet (Fig. 65).
d) Generously apply the dry lubricant to the insides of the D-ring housings located on the
outer ladder assembly side rails (Fig. 66).
e) Wipe off any excess lubricant from all areas with a dry rag before retracting the
RATCHET levelers and returning the ladder to service.
2. Slider release lubrication instructions
a) Start by removing the outer ladder assembly with the RATCHET Levelers from the
inner ladder assembly.
b) Generously apply the dry lubricant inside the small center hole above the RATCHET
leveler release slider, angling both to the left and the right (Fig. 67-68).
c) Spray where the leveler leg slides along the upper and lower brackets inside the outer
ladder rails, making sure not to get any of the lubricant on the ladder feet (Fig. 69-70),
then extend and retract the legs several times.
d) Wipe off any excess lubricant from all areas with a dry rag before retracting the
RATCHET levelers and returning the ladder to service.
18
64
67
65
68
69
66
70