DUROFIX RZ6008 Serie Manual De Instrucciones página 14

1. Make sure that the motor assembly switch is OFF.
2. Make sure that the motor assembly and vibrator assembly are securely connected.
3. Attach the battery to the motor assembly and close the battery cover.
4. Hold the handle and then, head assembly.
5. Turn ON the switch of the motor assembly.
※ "When turning on the switch after turning it off within 3 seconds, the
protection circuit of the battery may work and the motor may not start up.
※ Push the switch lock button when use continuously.
6. Insert the vibrator perpendicularly into the concrete at a pitch in the effective
compacting range.
※ The effective compacting range for the vibrator is an area that has a diameter
approximately 10 times the diameter of the vibrating part.
※ After the vibrator has been inserted into the concrete as far as it will go,
operate it until the mortar uniformly comes to the surface and has a luster to
it, then move on to the next location.
※ If placing a vibrator to one point for long time, it may cause aggregate
separation.
7. When removing the vibrator from the concrete, remove it gently so that no hole is
left.
8. After work has been completed turn the motor switch OFF.
9. Remove the battery from the main unit.
※ Charge the battery after use.
WARNING
solutions.
NOTE
This vibrator is lubricated before it leaves the factory. This lubrication
should last for the life of the vibrator. No further lubrication is required.
CLEANING AND TRANSPORTATION AFTER USE
1English1
OPERATION
MAINTENANCE
Remove the battery pack from this vibrator before cleaning
English -13