illy X7.1 Manual De Instrucciones página 22

- Remove the tank and fi ll it with 1 l of water (up to the MAX
level). Remove the capsule and capsule holder.
- Pour the descaling solution into the tank fi lled with water and
stir until it is completely dissolved.
- To make this operation easier, it is recommended to remove
the outer end part of the steam wand.
- Place a container with a minimum 1-litre capacity under the
coffee brew head and the steam wand.
Turn on the machine: within 15 se-
conds from power on, press and
hold the
chine gives out 4 acoustic signals
(3 short ones and 1 long one). Rele-
ase the button.
The button fl ashes: the machine is ready to start the des-
caling cycle.
22
Note: you can temporarily stop the cycle by pressing the
button. Press the
1 Litre
button until the ma-
- Remove and thoroughly wash the tank. Fill it with 1 l of fresh
water, up to the MAX level.
- Empty and refi t the container with a minimum 1-litre capac-
ity under the coffee brew head and the steam wand.
Press the button once to start
the descaling cycle.
The and buttons fl ash al-
ternately.
Water is dispensed intermittently
from the coffee brew head and the
steam wand (duration: 14 minutes).
button again to resume the cycle.
The machine gives out a long
acoustic signal to indicate that the
descaling phase is over. At this
point it is necessary to rinse the
circuits to remove any descaling
solution residue.
The button keeps on fl ashing.
1 Litre