Brigmton BBOARD-63-N-A-R-P Manual De Instrucciones página 19

- Do not overload lithium batteries. The battery pack consists of lithium
batteries.
IMPORTANT:
Do not ride the Scooter while it is charging!
- During charging, the LED light of the battery charger will be red.
- When finished charging, the LED light of the battery charger will be
green.
- When charging is complete, disconnect the battery charger from the
mains and the Balance Scooter.
Steps for loading:
- Make sure that the scooter, charger and DC power supply of the balance
scooter remain dry.
- Use ONLY the charger that is attached. Use of any other charger may
damage the product or create other potential hazards.
- Plug the power adapter into the power port on the back of the scooter
and into a standard power outlet. - Make sure that the green indicator on
the adapter lights up.
- When the red indicator on the charger lights, this indicates that it is
charging properly; Otherwise check if the line is connected properly.
- When the indicator light on the charger changes from red to green, this
indicates that the battery is fully charged. In this case, please stop loading
it. Overcharging will affect battery life.
- Charging can take up to 3 hours. Do not charge the battery for more than
3 hours. Disconnect the charger from the balance scooter board and the
power outlet after 3 hours. Overcharging will reduce battery life.
- Do not charge the product for long periods of time.
- Never charge the product without supervision.
- The product should only be charged at temperatures between 0 ° C and +
45 ° C.
- If it is charged at higher or lower temperatures, there is a risk of reduced
battery performance and potential risk of product damage and personal
injury.
- Charge and store the product in an open, dry area away from flammable
materials.
- Do not charge in sunlight or near flames.
- Do not charge the product immediately after use. Allow product to cool
for one hour before charging.
- If the product is left to other people, for example, during a holiday
period, it should be partially charged (20-50% load). Not fully charged.
- When shipped from the factory, the product is often only partially
charged. Keep the product in a partially charged state until it is to be used.