Peach PC200-20 Instrucciones De Servicio página 7

■ Always carry out a few test cuts - especially when
cutting a new material.
■ For best results, press down firmly on the cutting head,
then slide it slowly and steadily.
Operation of the Corner Rounder
The corner rounder supplied is atttached to the trimmer
with Velcro, so that it is always ready to hand. It produces
a clean, rounded corner on up to 3 sheets of 80 gsm
paper simultaneously.
Detach the corner rounder from the Creative Trimmer and
place it on a sturdy work surface.
Position the paper in the silver corner.
Press the raised button down firmly.
The cut waste is collected in the corner rounder. To
empty, turn the corner rounder upside down and remove
the transparent lid.
Replacing the Cutting Head
If the blades of this Creative Trimmer have become dull,
they can be replaced. New cutting heads, fully assembled
with four blades, are available from your Peach dealer or
at www.peachstore.com
Remove the end cap by sliding it up.
Remove the guide rail and cutting head.
Insert the new cutter head, reinstall the guide rail and
push the end cap back into its original position.
Caution: Do not touch the blades - they are extremely
sharp!
Replacing the Cutting Mat
The rotating blades run on a replaceable cutting mat.
Over time, this mat wears out and must be replaced.
The cutting mat can be used on both sides to extend the
service life.
Remove the end cap by pushing it upwards.
Remove the guide rail and the cutting head.