Charging The Rechargeable Battery - Carrera RC Power Wave Instrucciones De Montaje

Ocultar thumbs Ver también para Power Wave:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 16

Charging the rechargeable battery

1
2
2
RED = Charging
GREEN = Ready
Installing the rechargeable battery
1
2
Fitting in the batteries
1
2
First connect the Carrera RC rechargeable
battery to the battery charger supplied. The
connection terminals between the battery
and the charger are designed to prevent
connection with the wrong polarity. Connect
the charger to a power source.
When the battery is properly connected and
charging normally, the red LED is constantly
lit. Once the battery is fully charged, the red
LED switches to green. The battery can now
be disconnected and installed in the Carrera
RC boat.
The boat is now ready for use.
After use, the battery must be allowed to cool
down for at least 20 minutes before it can be
fully recharged. Failure to observe this
pause may damage the battery.
Using a screwdriver, remove the cover of the
battery compartment in the Carrera RC boat.
Connect the end of the cable from the
Carrera RC boat with the charged battery.
Put the battery in place.
Replace the compartment cover using
a screwdriver.
Press the release button, then take the
battery compartment out of the controller.
Take care when inserting the batteries that
the polarity is correct. Push the battery
compartment back into the controller until
it clicks into place.
Now you can drive the boat
1
2
Let's practise!
30km/h
1
• Before launching from the bank, make sure the boat and the controller are con­
nected (see above)
• Avoid constant motor operation.
• Bring the boat back to the bank after about 20 minutes to change the battery
• After use, remove or disconnect the battery.
• Never run more than 2 batteries down one after the other. After running down
two fully­charged batteries, a pause in running for at least 20 minutes is essen­
tial.
• After sailing it, clean the Carrera RC boat carefully
10
On first using it, the boat must be con-
nected with the controller.
To do this, you first switch on the con-
troller, plug in the battery to the boat,
switch the boat on and then press the
small button located in the battery com-
partment until the LED lamp lights up
continuously.
A connection can only be made
when the boat is in contact with the
water.
Switch on the Carrera RC boat using
the ON/OFF switch.
Caution: this boat can reach speeds
up to 30 km/h.
When first starting, be very careful
when operating the gas pedal. Practice
running slowly for at least two to three
full charges of the battery before you
start practising faster manoeuvres.

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

300001

Tabla de contenido