Hold - Olympus DM-20 Manual De Instrucciones

Hold

Running state when HOLD is set
1: State of the recorder, 2: HOLD of the recorder, 3: HOLD of the remote controller, 4: Button
operation on the recorder, 5: Button operation on remote controller
1 2
5
On
On
STOPS
Off
On
On
Running
Off
*1: Pressing any button makes clock display blink for 2 seconds but the recorder does not start.
*2: The recorder stops when playback completes or recording terminates due to no memory space.
Note
The alarm will sound at the scheduled time even if the recorder is set to hold. The recorder begins to play the
file associated with the alarm when you press any button.
54
3
Not The display goes out after "HOLD"
connected blinks for 2 seconds.*
Off The display goes out after "HOLD"
blinks for 2 seconds.*
On Normal operation
Not If HOLD is applied during playback
connected (recording), operation is disabled with the
playback (recording) state unchanged.*
Off If HOLD is applied during playback
(recording), operation is disabled with the
playback (recording) state unchanged.*
On Normal operation
Setting the HOLD switch to the HOLD position.
If you set the recorder to HOLD status by sliding
the HOLD switch in the direction of the arrow, the
current conditions will be preserved, and all buttons
and switches except the HOLD switch will be
disabled. This feature is useful when the recorder
has to be carried in a bag or pocket.
Remember to reset the HOLD switch when using
the recorder.
4
1
Normal operation. If the recorder
1
stops after button operation, the
display goes out 20 seconds later.
Button operation on the remote controller
is invalid.
2
Normal operation. If the recorder
stops after button operation, the
2
display goes out 20 seconds later.
Button operation on the remote controller
is invalid. However, the REC lamp is lit
while the recorder is recording.
5