Replacing Cord Cover - peerless-AV UV492 Guia Del Usuario

Replacing Cord Cover

1. Run cables across foam gasket block. Leave approximately 1/2" (13mm) between cables to
ensure a proper seal.
2. Replace cord cover (B) and (4) thumb screws (D). Fasten thumb screws until gasket on cord
cover plate is fully compressed to back of television. Cables will seal between display's gasket
and cord cover's gasket as cover is pressed into place. Route cables through opening at end of
cord cover.
CAUTION
• Ensure bend radius limits for cables do not
exceed limits set by the manufacturer.
• Ensure cables are seated properly in the
cable gland to avoid potential damage to
cables when cord cover is installed.
• Do not remove lanyard that connects the
cord cover to the display.
B
D (4)
Do not overtighten screws
9 2017-02-17 #:180-9099-1