Troubleshooting - Ego Power+ HT2410 Manual De Funcionamiento

TROUBLESHOOTING

PROBLEM CAUSE
◾
◾
◾
◾
Hedge trimmer
dose not work.
◾
◾
◾
◾
Excessive
vibration or
◾
noise.
◾
56V LITHIUM-ION CORDLESS HEDGE TRIMMER — HT2410/HT2410-FC
The battery pack is not
attached to the hedge trimmer.
No electrical contact between
the hedge trimmer and
battery.
The battery pack is depleted.
The battery pack or the hedge
trimmer is too hot.
The front and rear switch
levers are not depressed
simultaneously.
The blade is jammed.
Dry or corroded blades.
Blades or blade support is bent.
Bent or damaged teeth.
Loose blade bolts.
SOLUTION
◾
Attach the battery pack to the hedge
trimmer.
◾
Remove the battery, check contacts
and reinstall the battery pack.
◾
Charge the battery pack.
◾
Remove the battery pack from the
hedge trimmer and allow the battery or
the hedge trimmer to cool until the tool
and battery pack's temperature drops
below 152°F (67°C).
◾
Press the lock-off button first and then
press the switch levers in the front and
rear handle simultaneously.
◾
Remove the battery pack from the tool,
remove the obstruction carefully, then
reinsert the battery and restart the tool.
◾
Lubricate the blades, following the
instructions in the "LUBRICATING THE
BLADE" section in this manual.
◾
Replace with a new blade or support.
Contact EGO service center for blade
replacement service.
◾
Replace with a new blade. Contact EGO
service center for blade replacement
service.
◾
Tighten the blade bolts. Use a hex wrench
and turn the bolt clockwise to tighten.
23