Mounting The Guard - EGO RBA2100 Manual Del Operador

MOUNTING THE GUARD

WARNING:
before the rubber broom attachment is
connected to the power head.
1. Loosen and remove the bolt from
the guard with the supplied Allen
key (Fig.2).
2. Lift the rubber broom attachment
shaft and remove the end cap from
the shaft.
3. With the slot in the guard aligned
with the rib on the end of the shaft,
pass the guard through the shaft
until the screw holes in the guard
and in the shaft are aligned
(Fig. 3 & 4).
4. Use the supplied Allen key to tighten
the bolt in the clockwise direction,
to lock the guard securely.
Install the guard
RUBBER BROOM ATTACHMENT — RBA2100/RBA2100-FC
2
3
4
Bolt
Slot
Rib
15