Selecting The Place Of Installation - IARP GELE 200 CSV Instrucciones De Empleo Y Manutención

8. INSTALLATION
8.1 STORAGE AND DISMANTLING
Keep all packaging away from children. For each subsequent handling of the cabinet, the use
of the wooden platform is recommended. Carefully remove the packaging, taking care not to
damage the components and not to throw away those that will be needed for assembly.
The unit is shipped anchored onto a wooden base and protected by corner posts,
cardboard top and nylon wrapping. It must only be handled using a fork lift truck
with adequate power to the load.
Positioning the appliance horizontally or on its side or upside down is to be strictly
avoided. During freezer transport, the angle between the freezer casing and the
ground must not exceed 45°.
If the freezer is overturned or tilted during transport, wait approximately 2 hours
before switching it on.

8.2 SELECTING THE PLACE OF INSTALLATION

In selecting the place of installation, ensure that the following instructions are observed, this being vital for proper and
troublefree working of the cabinet:
• Do not install the cabinet outdoors.
• Do not install the cabinet in the vicinity of heating radiators or other heat sources.
• Do not install the cabint where it is exposed to direct sun light (e.g. through windows).
• Do not install the cabinet where it is exposed to drafts from ventilators open doors.
• Pay attention to air outlet from air conditioners/ ventilators.
• Keep the air intake and outlet area around the plinth area of the cabinet clear of cartons and other obstacles.
• The compressor and condenser generate heat and, therefore, need to be ventilated properly. Rooms with no ventilation
are not suited for installation of the appliance. Therefore, it should be installed in a room with an opening (window or
French window) that provide the appropriate amount of air re-circulation.
• It is also important to install it in a free humidity room.
• It is necessary taht the condensing unit obtains a good circulation of air around it; also the area around the condensing
unit should not be obstructed by boxes or other objects; keep a distance from the wall of 10 cm. at least.
THE REFRIGERATOR IS NOT SUITABLE FOR WORKING IN DANGEROUS ENVIRONMENT WITH RISK OF FIRE,
EXPLOSIONS OR RADIATIONS.
Operation is regular with ambient temperature indicated on technical data plate.
8.3 LOADING
• It is fundamental not to exceed the load limits indicated to avoid altering correct air circulation and
thereby avoid a higher product temperature.
• Never place hot food inside the freezer; wait for the food to cool naturally outside.
• Never fully fill the freezer. There must be reasonable space between the products for better freezing.
Air-Condition
-13-