Assembly; Operation - RIDGID R842301 Manual Del Operador

ASSEMBLY

UNPACKING
This product has been shipped completely assembled.
 Carefully remove the tool and any accessories from the
box. Make sure that all items listed in the packing list are
included.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the tool.
 If any parts are damaged or missing, please call
1-866-539-1710 for assistance.
PACKING LIST
Impact Driver
Bit
Tool Bag
Operator's Manual

OPERATION

WARNING:
Do not allow familiarity with tools to make you
careless. Remember that a careless fraction of
a second is sufficient to inflict severe injury.
WARNING:
Always wear safety goggles or safety glasses
with side shields when operating tools. Failure
to do so could result in objects being thrown into
your eyes resulting in possible serious injury.
WARNING:
Do not use any attachments or accessories
not recommended by the manufacturer of this
tool. The use of attachments or accessories not
recommended can result in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Driving screws, lag bolts
 Tightening nuts and bolts
 Removing screws, nuts, and bolts
This product will accept RIDGID 18 V lithium-ion batter
packs and RIDGID 18 V nickel-cadmium battery packs.
For complete charging instructions, refer to the Operator's
Manual for the battery packs and chargers listed in the
General Safety Rules.
WARNING:
If any parts are damaged or missing do not operate
this tool until the damaged or missing parts are
replaced. Failure to heed this warning could result
in serious personal injury.
WARNING:
Do not attempt to modify this tool or create
accessories not recommended for use with this
tool. Any such alteration or modification is misuse
and could result in a hazardous condition leading
to possible serious personal injury.
WARNING:
To prevent accidental starting that could cause
serious personal injury, always remove the battery
pack from the tool when assembling parts.
BATTERY PROTECTION FEATURES
RIDGID 18 V lithium-ion batteries are designed with features
that protect the lithium-ion cells and maximize battery life.
Under some operating conditions, these built-in features
may cause the battery and the tool it is powering to act
differently from nickel-cadmium batteries.
During some applications, the battery electronics may signal
the battery to shut down, and cause the tool to stop running.
To reset the battery and tool, release the trigger and resume
normal operation.
NOTE: To prevent further shut down of the battery, avoid
forcing the tool. Switching to a lower speed will also prevent
shut down.
If releasing the trigger does not reset the battery and tool,
the battery pack is depleted. If depleted, the battery pack will
begin charging when placed on the lithium-ion charger.
CAUTION:
To reduce the risk of injury, charge only RIDGID
lithium-ion batteries and RIDGID nickel-cadmium
batteries on the chargers listed in the General
Safety Rules. Other types of batteries may burst,
causing personal injury or damage.
NOTE: The RIDGID 18 V nickel-cadmium battery pack is
shown in the following illustrations.
TO INSTALL BATTERY PACK
See Figure 2, page 11.
 Place the battery pack in the impact driver, aligning raised
rib on battery pack with groove in the driver's battery
port.
7 - English