dirna Bergstrom TRP COMPACT Instrucciones De Montaje página 42

COMPACT
EN
Detailed instructions on power wiring assembly
Open the cover of the upper right glove box and
6
remove the two screws of the lower side.(A)
6
A
Slightly separate the glove box and gather in the
6a
original cabling by inserting your hand through
the lower side. This cabled line is protected
by a 40 amp fuse in the original central fuse
boxes.
If the connector for the existing wiring is
!
already in use (for example, if connected to
a microwave), add a new cabling connector,
similar to the existing one in the box, from the
glove compartment to the central box.
Protect the cable supplying the current with a
separate new 40A fuse. (Keep the 40A fuse in
the central fuse box)
Direct the cabled line of the unit between the
6b
ceiling and the upholstery above the glove box
and plug in both connectors. Once connected,
the unit will carry out a test function; all the lights
go on and off, indicating that the unit is ready.
Fix unit wiring loom to aluminium bracket as
shown in picture, using plastic strips.
IMPORTANTE
In the case that, for a mistake, the wires were shifted inverting the polarity, the electronic control of the unit
would start to emit intermitent beeps. In that case, do not touch any of the buttons of the control panel neither
the remote control, because the electronic control of the unit could result electronic system with irreversibly
damages. Please, consult the User´s Guide before starting the unit.
ALL EURO 5 MODELS
With access by right glove compartment
6
6b
42
®