Nowsonic AUTARK ID07 Manual Del Usuario página 11

www.nowsonic.com
Wiring for Master/Slave mode
In Master/Slave mode, up to 16 Autark units can be linked whereat the
first unit serves as the master and all following units work as slaves. The
slave units receive their control messages from the master.
Proceed as follows:
1)
Connect a XLR cable (not supplied) to the
the rear panel of the master unit.
2)
Connect the other (male) plug of the cable to the
socket of the first slave device.
3)
Connect additional slave units according to this pattern (Slave
DMX Out to Slave DMX In).
Next, you must set the devices to Master/Slave mode via their menus.
The operation in the menu is described from page 7.
Wiring in mode
DMX
Using a capable controller, you can control Autark
DMX
2, 6 or 9 channels in mode. For wired control, proceed as follows:
DMX
1)
Connect a standard high quality XLR audio cable (not supplied)
to the DMX out socket of the controller.
NOTE:
A suitable audio cable connects the two signal leads
XLR
to 2 and 3, while ground is soldered to
PIN
sure that the wiring doesn't change within the cables: a polarity
error or short circuit between the Pins will at least impair or com-
pletely stop the control functionality.
2)
3)
DMX OUT
socket on Next, you must enter an individual
via its menu. The operation in the menu is described from page 7.
DMX IN
Wireless control via
Autark
implement control signals from a suitable
te control via
1)
2)
3) Unfold the antenna of Autark ID07 to improve the reception
over 1,
ID07
4)
5) Finally, press the button at the external DMX transmitter for
1. Please make
PIN
11
Nowsonic Autark ID07
Connect the other (male) plug of the cable to the
socket of the first Autark unit.
Connect additional Autark units according to this pattern (Slave
to Slave ).
DMX OUT DMX IN
DMX
incorporates a
ID07 DMX
, proceed as follows:
DMX
Connect a XLR audio cable (not supplied) to the DMX out socket
of the controller.
Connect the other (male) plug of the cable to the DMX in socket
of an optional DMX transmitter (e. g. Nowsonic WRX-1).
quality and activate the WIRELESS SWITCH:
should now switch from Addr to A001.
Now you must enter an individual DMX address for the Autark
unit via the menu. The operation in the menu is described from
page 7.
establishing and setting up the connection.
User manual
DMX IN
DMX address for each Autark unit
receiver that can receive and
transmitter. For remo-
DMX
The LED display
GB