Velleman CHLSC1 Manual Del Usuario página 6

strips, always connect the common [10] to the LED strip as well as the
applicable colour output. Never short-cut the outputs.
Linking controllers
 Multiple controllers can be linked using the data bus. Selecting a setting on
one of the controllers will automatically change the setting on all the other
connected controllers.
 Simply link the data port "+" [8] terminals of the controllers to each other as
well as the data port "-" [9] terminals using an AWG 18 (Ø1.024mm) wire.
Notes:
Maximum length of the data bus is 50m.
Each controller requires its own power supply.
Never link controller outputs.
Press any key on the remote control to start synchronizing.
Power supply
 The power supply (not incl.) should only be connected when all other
connections are made. Make sure there is no power on the wires.
 Depending on the used type of LED strip(s), connect a 12VDC or 24VDC
power supply to the controller.
IMPORTANT: the used power supply must match the connected LED-strips!
 Connect the positive side to the "+" terminal [6] and negative side to the "-"
terminal [7]. Use AWG 12 wire (Ø2.053mm).
7. Operation
 Switch the power supply on.
 The controller output can be selected either by pressing the function select
button [5] or via the remote control (see §5).
 The status LEDs [2], [3] and [4] indicate the status of the output ports
resp. [11], [12] and [13].
8. Battery
 Refer to the illustration on page 2 for instructions on how to remove the
battery holder from the remote control.
 Insert a new CR2025 Lithium battery in accordance with the polarity
markings on the battery holder.
 Reinstall the battery holder into the remote control.
WARNING:
Do not puncture or throw batteries in fire as they might
explode. Dispose of batteries in accordance with local
regulations.
Keep batteries away from children.
V. 03 – 12/11/2015
CHLSC1
6 ©Velleman nv