Trevi TT 1072 DAB Manual De Usuario página 13

ENGLISH
SPEAKER CONNECTION
Connect the speaker cable to the sockets (35/36) of the appliance.
SUPPLY
This unit works with 12V
Do not connect the appliance to sockets with a voltage other than that indicated.
Note: Unless otherwise specified, the tooltips are valid for both the device and the remote control.
POWER ON / STANDBY
1. Plug the supplied power supply cable into the power socket (34) on the device and the power supply plug into a power outlet.
2. Press the knob (13). The appliance will switch on. Only the first time it is turned on, the unit will scan the DAB stations present;
wait a few moments for the scan operation to end.
3. Press the knob (13) again to put the appliance in Stand-by mode.
This appliance is equipped with an auto-off system for energy saving. After a certain period of non-use, the appliance will go into
standby automatically. Press the knob (13) to turn it back on.
TIME/DATE SET
1. With the appliance in standby, press the MENU button (12) for a long time. Move within the menus using the keys (27) or (26)
and confirm with the SELECT key (25).
2. The indication SYSTEM appears on the display, confirm with the SELECT button. Select the TIME item and confirm.
3. Select the SET TIME / DATE item and set the current time and date.
4. Select the 12/24 hour item to set the time display (12 / 24H).
5. Select the AUTO UPDATE item for automatic time / date adjustment via the FM, DAB radio or from both sources.
VOLUME CONTROL
1. Turn the Volume Control (13) on the appliance or press the VOL + or VOL- (13) button on the remote control to increase or
decrease the volume.
FM RADIO
1. Switch on the appliance and press the FUNCTION button (11) until the indication FM appears on the display.
2. Press the buttons (27) or (26) on the unit several times, or the buttons (12) on the remote control to carry out a step-by-step
search.
3. Press and hold the buttons (27) or (26) on the unit for a few seconds, or the buttons (12) on the remote control to tune in to
the next or previous radio station with the best signal received.
4. To store a radio station:
- Move to the frequency to be stored, long press the MODE key (14).
- With the buttons (27) or (26) select the memory number where you want to save the radio station.
- Press the SELECT button (25) to confirm.
- The device is capable of storing up to 30 stations.
5. To select a stored radio station, use the ALBUM / PRESET UP / DOWN (28/29) buttons.
6. To carry out a scan with automatic storage of radio stations, press the TUNER SCAN button (24) for a long time. The device is
capable of storing up to 30 stations.
7. Press the INFO button (12) to view various information transmitted by radio stations on the display.
8. Long press the MENU key (12) to access the FM radio settings menu, move within the menus using the keys(27) or (26) and
confirm with the SELECT key (25). The following settings are available:
- SCAN SETTING: it is possible to select whether all stations (All station) or only those with strong signal (Strong station) are
stored during the automatic search.
- AUDIO SETTING: it is possible to select listening in MONO (Forced mono) or STEREO (Stereo allowed)
Note: To obtain the best FM reception, extend and orient the antenna (37). If the reception is not good, try adjusting the length and
orientation of the antenna differently, however the quality of FM reception depends a lot on the place where the device is placed.
1A power supply (furnished).
TT 1072 DAB
13