Automatic Standby Mode - Focal TRIO6 BE Manual De Uso

TRIO6 BE
U s e r m a n u a l
21
INPUT
EQ'S
FOCUS
TRIO6 Be FOCUS mode diagram.
8 - ON/OFF
The ON/OFF switch turns the internal amplifiers on or off.

Automatic Standby mode

TRIO6 Be monitors feature a "Standby" mode. When you turn on the power to the monitors, they are already
in "Standby" mode. To switch from "Standby" mode to "On", send an audio signal to the monitor by gradually
increasing the volume of the audio source. After 15 minutes without an audio signal, the monitors automatically
go into "Standby". When the "Standby" mode is activated, power consumption is inferior to 0.5W.
9 - VOLTAGE SELECTION
This slide switch allows you to select the voltage according to the mains power supply depending on the
country you're in. There are two options: 115V or 230V. To change the voltage, proceed as follows:
1) Turn off the monitor and unplug the power cable
2) Using a flat-head screwdriver, remove the fuse situated below the power socket .
11
3) Replace the fuse with one having the appropriate values:
a. 115V: class T fuse, value 3.15A
b. 230V: class T fuse, value 1.6A
4) Using a Phillips screwdriver, slightly loosen the screws , and remove the protection cover from the voltage
12
selector.
5) Switch the voltage selector to the appropriate setting using a flat-head screwdriver.
9
6) Using a Phillips screwdriver, put the protection cover for the voltage selector back into place and slightly tighten
the screws .
12
7) Reconnect the power cable .
10
8) Turn on the power to the monitor using the Power ON/OFF switch .
8
10 - POWER SOCKET
Connect the power supply cable supplied to this connector socket.
11 – FUSE HOUSING
This is where the fuse is located to protect the monitor. If necessary, replace the fuse as explained in section
9 - VOLTAGE SELECTION.