Important Safety Information - WAGNER CONTROL SPREY HVLP Manual Del Propietário

Important Safety Information

To reduce the risks of fire or explosion, electrical shock and the injury to persons, read and understand all instructions included in
this manual. Be familiar with the controls and proper usage of the equipment.
Indicates a hazardous situation which, if not avoided,
could result in death or serious injury.
HAZARD: EXPLOSION OR FIRE
Solvent and paint fumes can explode or ignite.
Severe injury or property damage can occur.
PREVENTION:
• Provide extensive exhaust and fresh air introduction to keep
the air within the spray area free from accumulation of
flammable vapors.
• Avoid all ignition sources such as static electric
sparks, open flames, pilot lights, electrical
appliances, and hot objects. Connecting or
disconnecting power cords or working light
switches can make sparks.
• Do not smoke in spray area.
• Fire extinguisher must be present and in good working order.
• Place turbine in a well-ventilated area at a maximum distance
from spray area, preferably into a separate, well-ventilated
room. Flammable vapors are often heavier than air. Floor
area must be extremely well-ventilated. The turbine contains
arcing parts that emit sparks and can ignite vapors.
• Follow the material and solvent manufacturer's warnings and
instructions.
• Do not use materials with a flashpoint below 70°F (21°C).
Flashpoint is the temperature that a fluid can produce enough
vapors to ignite (see coating supplier).
• Plastic can cause static sparks. Never hang plastic to enclose
the spray area. Do not use plastic drop cloths when spraying
flammable materials.
HAZARD: EXPLOSION HAZARD DUE TO
INCOMPATIBLE MATERIALS.
Will cause property damage or severe injury.
PREVENTION:
• Do not use materials containing bleach or
chlorine.
• Do not use halogenated hydrocarbon solvents such as bleach,
mildewcide, methylene chloride and 1,1,1--trichloroethane.
They are not compatible with aluminum.
• Contact your coating supplier about the compatibility of
material with aluminum.
English
operating the equipment. Save these instructions
• Read all safety information before
HAZARD: HAZARDOUS VAPORS
Paints, solvents, insecticides, and other
materials can be harmful if inhaled or come in
contact with the body. Vapors can cause
severe nausea, fainting, or poisoning.
PREVENTION:
• Use a respirator or mask if vapors can be
inhaled. Read all instructions supplied with the
mask to be sure it will provide the necessary
protection.
• Wear protective eyewear.
• Wear protective clothing as required by coating manufacturer.
HAZARD: GENERAL
Can cause severe injury or property damage.
PREVENTION:
• Read all instructions and safety precautions before operating
equipment.
• Follow all appropriate local, state, and national codes
governing ventilation, fire prevention, and operation.
• The United States Government Safety Standards have been
adopted under the Occupational Safety and Health Act
(OSHA). These standards, particularly part 1910 of the
General Standards and part 1926 of the Construction
Standards should be consulted.
• Use only manufacturer authorized parts. User assumes all
risks and liabilities when using parts that do not meet the
minimum specifications and safety devices of the turbine
manufacturer.
• Power cord must be connected to a grounded circuit.
• All hoses, swivels, guns and accessories must be rated at or
above 10 PSI.
• Do not spray outdoors on windy days.
• Wear protective clothing to keep paint off skin and hair.
• Never aim spray gun at any part of the body.
• Hose may become hot and cause skin burn.
• Use only Wagner HVLP hose.
Household use only.
Minimum gauge for extension cords
Voltage
Ampere
rating
120V 25-50 100
range
2 - 3 18
2
Cord length (feet)
150 200 250 300
16 14 14 12 12
400 500
10 10