Status / Alarm Codes - Siel SAFEPOWER-EVO-HF 10 kVA Manual De Instalacion Y Uso

S /
TATUS ALARM
Using a sophisticated self-diagnostic system, the UPS can check and indicate on the display panel its status and any
errors and/or faults that have occurred during its operation. When a problem arises, the UPS signals the event by
showing the code and corresponding type of alarm on the display.
Status: indicates the current status of the UPS.
CODE
S01
S02
S03
S04
S05
S06
S07
S08
S09
S10
S11
S12
S13
Command: indicates that a command has been activated.
CODE
C01
C02
C03
C04
C05
C06
C07
C08
Warning: messages that refer to a specific configuration or operation of the UPS.
CODE
W01
W02
W03
W04
W05
IV330 Rev.001 SIEL S.p.A.
Data di emissione: 2011-09-28
C
ODES
BOOST stage or battery-charger locked – load not powered
Frequency converter - load powered by inverter
Remote battery charger power-off command
Programmed power-off command imminent
Synchronization disabled (UPS in Free running mode)
DESCRIPTION
Precharging
Load not powered (stand-by status)
Power-on phase
Load powered by bypass line
Load powered by inverter
Battery operation
Waiting for batteries to recharge
Economy mode enabled
Ready for power on
UPS locked – load not powered
UPS locked – load on bypass
DESCRIPTION
Remote power-off command
Remote load on bypass command
Remote power-on command
Battery test running
Manual bypass command
Emergency power-off command
Load on bypass command
DESCRIPTION
Battery low warning
Programmed power-off enabled
Bypass disabled
Pag. 97 di 252 + FR