Orbegozo PHF 40 Manual De Instrucciones página 13

PHF 40
REMINDER:
Do not allow children to use the device.
Do not place other heating sources close to the device when it is on.
Ensure that your electrical circuit is adapted to a 16 Ampere device.
ASSEMBLY
CAUTION: For safety reasons, carefully assemble the device as set out below
and make sure the heating element, tubes and base are tightly fitted, then
bolted to each other.
1. Remove out 4 pcs setscrews of the heating element as drawing with the
screwdriver and take off the protection net. Please remove soft foam gently as
per the direction of the arrowhead and then put the protection net in with 4 pcs
screws again.
2. ASSEMBLY TO THE HEATING ELEMENT
Remove all of the parts from the box and place them so that they are within
reach during the assembly. See Figure 1 below.
The electrical cable attached to the heating element must be inserted through
the inside of the tube section corresponding to the heating element. The
heating element must be turned over and remain stable. Gently turn the tube in
its setting on the heating element without attaching it for the time being.
13