Descargar Imprimir esta página

Stanley 7629102430 Manual De Instrucciones página 2

Publicidad

Idiomas disponibles

Idiomas disponibles

READ ALL INSTRUCTIONS/LISEZ TOUTES LES INSTRUCTIONS/
LEA TODAS LAS INSTRUCCIONES
WARNING: Read all instructions before operating the inverter. Failure to follow all instructions listed below may result in
electric shock, fire and/or serious injury.
AVERTISSEMENT: Veuillez lire toutes les instructions avant d'utiliser l'onduleur. Ne pas respecter toutes les instructions listées
ci-dessous peut entraîner un électrochoc, un incendie et/ou de graves blessures.
ADVERTENCIA: Lea todas las instrucciones antes de operar el inversor. El incumplimiento de todas las instrucciones enumeradas,
puede provocar descargas eléctricas, incendios y / o lesiones graves.
INSTALLATION/INSTALLATION/INSTALACIÓN
1
3
2
4
2
SAFETY GUIDELINES / DEFINITIONS
DANGER: Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.
WARNING: Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION: Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury.
CAUTION: Used without the safety alert symbol indicates potentially hazardous situation which, if not avoided, may result in property
damage.
RISK OF UNSAFE OPERATION. When using tools or equipment, basic safety precautions should always be followed to reduce the risk
of personal injury. Improper operation, maintenance or modification of tools or equipment could result in serious injury and property
damage. There are certain applications for which tools and equipment are designed. Manufacturer strongly recommends that this product
NOT be modified and/or used for any application other than for which it was designed. Read and understand all warnings and operating
instructions before using any tool or equipment.
WARNING: This product can expose you to chemicals including lead, which is known to the State of California to cause cancer and
birth defects or other reproductive harm. For more information go to www.P65Warnings.ca.gov.
IMPORTANT SAFETY INSTRUCTIONS
WARNING
• Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority
to operate the equipment.
• BE EXTREMELY CAREFUL WHEN USING THIS DEVICE. Improper use of this work light can result in injury or death. Follow all
safeguards stated in this manual in addition to normal safety precautions in working with electrical devices. DO NOT attempt to
service this device.
• When using outdoor portable work lights, always follow basic safety precautions to reduce the risk of electric shock and personal
injury.
• Failure to observe the following safety rules may result in FIRE, ELECTRICAL SHOCK, INJURY, or EXPOSURE TO EXCESSIVE
ULTRAVIOLET RADIATION.
• Use only 3-wire UL Listed outdoor extension cords that have 3-prong grounded plugs and grounded receptacles that accept the
work light's plug.
• Use only with an extension cord for outdoor use, such as with cord type SEW, SEOW, SEOOW, SOW, SOOW, STW, STOW, STOOW,
SJEW, SJEOW, SJEOOW, SJW, SJOW, SJOOW, SJTW, SJTOW, or SJTOOW.
• To avoid electrical shock, do not use near water or in areas where water may accumulate. Keep work light at least 16 ft. from
pools or spas. Keep plugs dry. Use only Ground Fault Circuit Interrupter (GFCI) protected receptacles when using this work light
in wet or damp locations. Receptacles are available with built-in GFCI protection and are to be used for this measure of safety.
NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
CARE AND MAINTENANCE
WARNING: Always make sure that the work light is unplugged and cooled down before attempting to clean it.
• Clean the lamp head, lens cover, and lamp stand regularly with a non-abrasive cleaner.
• Allow the work light to cool down completely before storing.
• Store in a safe place, out of the reach of children.
3

Publicidad

loading