Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
3 609 929 A32.book Seite 7 Montag, 11. Juli 2005 7:56 07
For cutting especially hard material, e. g.,
concrete with high gravel content, the dia-
mond cutting disc can overheat and be-
come damaged as a result. This is indi-
cated clearly by a ring of sparks that rotates
with the diamond cutting disc.
In this case, interrupt the cutting process and al-
low the diamond cutting disc to cool by running
frely at no-load speed for a short time.
Noticeable decreasing work progress and a rotat-
ing spark ring are indications of a diamond cutting
disc that has become dull. With brief cuts in an
abrasive material (e. g., chalky sand stone), it
can be sharpened again.
Maintenance and Cleaning
Before any work on the machine itself, pull
the mains plug.
For safe and proper working, always keep
the machine and the ventilation slots clean.
After finishing work, disassemble the diamond
cutting discs and clean the clamping parts and
the protective cover.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an authorized after-sales
service agent for Berner power tools.
In all correspondence and spare parts orders,
please always include the 6-digit order number
given on the nameplate of the machine.
WARNING! Important instructions for con-
necting a new 3-pin plug to the 2 wire cable.
The wires in the cable are coloured according to
the following code:
strain relief
live = brown
neutral = blue
Do not connect the blue or brown wire to the
earth terminal of the plug.
Important: If for any reason the moulded plug is
removed from the cable of this machine it must be
disposed of safely.
Service Indicator 9
When the carbon brushes are worn out, the ma-
chine switches itself off. This is indicated approx.
eight hours beforehand by the lighting or blinking
of the service indicator 9. The machine must then
be sent to customer service for maintenance (for
addresses, see Section "Service and Customer
Assistance").
Noise/Vibration Information
Measured values determined according to
EN 50 144 (lime-sand brick).
Typically the A-weighted noise levels of the prod-
uct are: sound pressure level: 97 dB (A); sound
power level: 110 dB (A).
Wear ear protection!
The typical weighted acceleration is 4 m/s
Disposal
Power tools, accessories and packaging should
be sorted for environmental-friendly recycling.
Only for EC countries:
tools that are no longer suitable for use must be
separately collected and sent for recovery in an
environmental-friendly manner.
To be fitted
We declare under our sole responsibility that
by qualified
this product is in conformity with the following
professional only
standards
EN 50 144 according to the provisions of the
directives 89/336/EEC, 98/37/EC.
Hans-Peter Artmann
CFO
Berner GmbH
Subject to change without notice
English - 7
Do not dispose of power tools into
household waste!
According to the European Direc-
tive 2002/96/EC on waste electrical
and electronic equipment and its in-
corporation into national law, power
Declaration of Conformity
or
standardization
Jean-Marie Biren
COO
2
.
documents:
Publicidad
Tabla de contenido
