LaserLiner AC-Tracer Manual De Instrucciones página 9

– Isolate the device from all measuring circuits before opening the battery compartment
cover.
– Observe the safety precautions of local and national authorities relating to the correct
use of the device and any prescribed safety equipment (e.g. electrician's safety gloves).
– Hold the device by the grip sections only. Do not touch the test prods during
measurement.
– Only connect the completely prepared device (transmitter with test leads plugged in)
to a power source. First disconnect the electrical circuit from the power supply and
only switch on again after wiring work has been completed. Lock the master switch to
prevent it being inadvertently switched on.
– Do not leave the sender running permanently. Only use during actual measurement.
After a measurement is taken, the transmitter (including test leads) must be removed
from the measured circuit.
– If possible, do not work alone.
– Carry out measurements in the vicinity of hazardous electrical installations only under
– The sender introduces the measuring voltage into the lines to be tested. This may impair
or damage sensitive electronic equipment (e.g. network cards). Therefore, please make
sure that any lines to be tested which belong to sensitive electronic equipment are
isolated before measurement.
– Only the original measuring leads may be used.
Symbols
Hazardous electrical voltage warning: Unprotected live components inside the
device housing may pose a risk of electric shock.
Danger area warning
Protection class II: The test device has reinforced or double insulation.
devices used in industrial applications which are permanently connected to the
Important notes. Must be observed.
!
AC-Tracer
09
EN