Connection To The Mains Supply; Using Your Brushcutter; Scope Of Application; Correct Brushcutter Operation - Solo 113 Manual De Instrucciones

Preparing the equipment for use ; Using your brushcutter

4.4 Connection to the mains supply

Fig. 7
Always secure the extension cable on the cable
retainer (23) on the motor housing.
To isolate the equipment, always pull the mains
plug from its socket, i.e. never pull on the cable to
remove the plug.

5. Using your brushcutter

5.1 Scope of Application

Only use brushcutters equipped with a nylon head
for cutting grass – particularly suitable around
obstacles - and for trimming light weeds and wild
growth near ground level. The nylon head is
particularly suitable for a soft cut, e.g. for clean
trimming around trees and posts.

5.2 Correct brushcutter operation

Observe the relevant safety instructions when using
the brushcutter.
Fig. 8
Carry the power tool on your r.h. side.
Approach the area to be cleared with the motor
switched OFF; then start the motor before dipping
the cutter into the working area.
ENGLISH 8
Fig. 9
With your thumb, initially press the locking button
(1) and then additionally the ON/OFF switch (2) with
your index finger. Then release the locking button
again. Release the ON/OFF switch to switch the
motor OFF again.
Dip the cutter 2/3 into the growth and use the
equipment like a scythe by stepping forward in
small steps and cutting from side to side.
Immediately switch OFF the motor, if you notice any
unusual vibrations or cuttings have wrapped
themselves around the cutting tool or have jammed
near the guard. Reduce the cutting tool speed by
pushing the cutter down onto the ground, until it
has come to a complete standstill. Pull the mains
plug from its socket and clear the cutting tool of
grass, brush etc. Check the entire power tool for
perfect condition.
When using the line head, only work with an
approved line length. If the contact protection
shield is properly fitted, cutting lines will always be
trimmed to the permissible length (trimming blade
integrated into the contact protection shield).
There is a high risk of injury, and the motor is
subjected to excessive loads leading to a risk of
damage, if nylon lines are left too long.

5.3 Adjusting the cutting line

When using a semi-automatic nylon head:
Fig. 10
(schematic diagram)